Home
Contribute
Contact Us
Browse all meetings
Home
Contribute
Contact Us
Browse all meetings
Open Source Ecology
/
Heat Exchange Coil Winding
/ 3 Feb 2012
Open Source Ecology
/
Heat Exchange Coil Winding
/ 3 Feb 2012
Previous Meeting
Next Meeting
⏯
Sync
Add meeting
Rate page
Subscribe
►
From YouTube:
Coil 8
Description
Gghghfhj
A
Does the weld weekend, but does it make it a weak spot for the coil not.
B
Really, because with the tegra are MIG welder you're, not getting the penetration that you do with a TIG welder as long as you keep your ear amperage down and your feet slow, it.
A
Would be.
B
Too much wider into them to do you've done lo you're on low.
A
I.
B
Have it I hit a pretty high setting because you want to get heat but having a low feed so that you don't get so that you're not trying to.
A
Force.
B
That a liar through the tube when it gets hot and you're on the low side on the mill amount of 200 L.
B
So now we want.
B
Looks like we on another six inches.
A
I got gonna.
B
Look at it right.
B
Ok now.
B
This last section, our air.
A
Gap.
B
So narrow, so we're going to take something a pry bar or something and to just bring it out so that it's a little more Universal better.
A
Off.
A
Actually,.
B
You could keep it.
B
This is like everything.
B
We call that.
B
Now, by not welding it on all of these, it gives us some flexibility still yep.
B
It's great.
B
Ideally,.
B
At a set set on there for that fit so by the time that just gets heated and bent back into place that should work.
So now it's just a matter of.
We probably should shorten that.
B
Probably should shorten that just a little bit.
B
You.
